Network Port Layout

Layout of the network ports is as follows. for FMADIO100G v2 1U Capture System (10G SFP+ management)

Layout of the network ports for FMADIO100G v2 1U Analytics System (40G QSFP+ Management)

TBD

1Gbe Management Ports

Systems shipped Prior to April 2021, default 1G management port is "L2"

System shipped after April 2021 default 1G management port is "L1"

This was made as L1 port can bridge the IPMI/BMC port (single RJ45 connection for both Server and BMC), the L2 port can not bridged. Please contact [e-mail] on how to swap.

IPMI Port

The IPMI Port is used for out of band communication with the system. It allows power on/off and KVM capabilities. Highly recommend connecting this. Default IP address is 192.168.0.93/24

Management Port

The Management ports can be 10G SFP+ or 40G QSFP+ depending on the system configuration. These can be run in standard, or link bonded / redundant setup.

FMADIO100Gv2 Capture systems,

Port Count	Port Speed	Interface
2	10G	SFP+
2	1G	SFP

FMADIO100G Gen2 Analytics Systems

Port Count	Port Speed	Interface
2	40Gbps	QSFP+
4	10Gbps	QSFP+ Breakout Cables

Capture Port

Capture ports can be configured in the following way

Port Count	Port Speed	Interface
2	100Gbps	QSFP28 (FEC or no FEC)
2	40Gbps	QSFP+
8	25Gbps	QSFP28 (Not released yet)
8	10Gbps	QSFP+ Breakout Cables

PPS Connector

The PPS connector is a 1 Pulse Per Second time synchronization cable. It runs on a 3.3V trigger signal the interface is SMA Coaxial cable